Bering-uClibc 4.x - User Guide - IPv6 Networking - External Network Connections

IPv6 Networking - External Network Connections
	Bering-uClibc 4.x - User Guide	Next

Native IPv6

TODO

If you use SixXS as your IPv6 tunnelbroker the procedure to configure Bering-uClibc 4.x is as follows:

Make sure you have the tun kernel Module loaded. Note that this relies on the crc32 kernel Module.
Configure Shorewall to accept the SixXS tunnel traffic. Add the following to /etc/shorewall/rules:

SixXS(ACCEPT)   fw      net

Install the aiccu.lrp Package and configure it using lrcfg.
- Specify your own username and password.
- Specify the relevant protocol and server. For example:

protocol tic
server tic.sixxs.net

svi aiccu start

Check for error messages in /var/log/syslog
If all is well, you should have a new network interface called "sixxs" which is effectively the IPv6 equivalent of your external IPv4 interface (e.g. eth0 or ppp0).
In the event of problems you may find the "test" mode of the "aiccu" command useful.

TODO