Difference between revisions of "Bering-uClibc 4.x - User Guide - Advanced Topics - Setting Up a Wireless Internet Connection"
Revision as of 19:55, 21 June 2013
|Advanced Topics - Setting Up a Wireless Internet Connection|
|Prev||Bering-uClibc 4.x - User Guide||Next|
WARNING - THIS PAGE REFERS TO NEW FUNCTIONALITY THAT IS CURRENTLY UNDER DEVELOPMENT AND NOT YET INCLUDED IN BERING-UCLIBC 4.X - WARNING Davidmbrooke 19:55, 21 June 2013 (UTC)
A common use case for a Bering-uClibc installation is to act as a router / firewall serving a local network and providing a connection to the Internet. Most often the Internet connection takes the form of a hard-wired link, for example via a Cable or ADSL modem. This has the advantage of offering a high-quality connection, often also with a high bandwidth. However in some cases a hard-wired Internet connection is not available but Internet connectivity is still desired. Many locations now have 3G (or even 4G) mobile telephony signals available and it is increasingly practical to use these to provide Internet connectivity as a temporary or permanent alternative to a hard-wired connection. Sometimes this is referred to as Mobile Broadband.
This article describes how to use a Mobile Broadband Modem (sometimes informally referred to as a "3G dongle" or "modem stick") with Bering-uClibc 4.x in order to provide an external network connection, either as the only source of Internet connectivity or as a secondary fall-back alongside a hard-wired primary connection.
A fundamental requirement is a hardware device which can connect to a mobile telephony network. Typically these are USB devices containing mobile telephony circuitry and an antenna of some sort (either internal or external). Older devices generally present themselves as a USB Modem which can be configured to run a Point-To-Point TCP/IP network link. Some more modern (higher-speed) devices present themselves as a USB Ethernet adaptor and include a built-in router and DHCP server.
A common complication is that the devices initially present themselves as USB storage devices (containing Windows device drivers) and need to be forced to switch to a different USB "mode" before they will work properly. This switching is performed automatically by Windows device drivers but under Linux a different approach is required, most often using the USB_Modeswitch utility.
Usually the only non-standard software Package required is
This relies on
libusb.lrp but that will be installed automatically if not already present.
Devices Which Act Like USB Modems
Devices Which Act Like USB Ethernet Adaptors
Known Working Devices
The Huawei E3131 is one of the more modern HSPA+ devices that presents itself as a USB Ethernet adaptor which uses the
cdc_ether kernel Module.
The Huawei E586 or "MiFi" Mobile WiFi contains a battery and combines a Mobile Broadband Modem with a Wireless Access Point. A common use case is to enable multiple Tablet Computers without USB ports to access Mobile Broadband over a WiFi connection, but it can also be connected via a short USB cable in which case it behaves like other Mobile Broadband Modem devices.