View source for Bering-uClibc 5.x - User Guide - Advanced Topics - Setting Up a Home Automation controller with heyu

{| summary="Navigation header" width="100%"
! colspan="3" align="center" | [[Bering-uClibc 5.x - User Guide - Advanced Topics - Setting Up a Home Automation controller with heyu |Advanced Topics - Setting Up a Home Automation Controller with heyu]]
|-
| width="20%" align="left"   | [[Bering-uClibc 5.x - User Guide - Advanced Topics - Setting Up a HTTP Anti Virus Proxy|Prev]]
! width="60%" align="center" | [[Bering-uClibc 5.x - User Guide]]
| width="20%" align="right"  | [[Bering-uClibc 5.x - User Guide - Advanced Topics - Modifying initrd.lrp|Next]]
|}
----

==Objectives==

This page explains how to turn a LEAF Bering-uClibc router into a Home Automation controller using the heyu.lrp Package. Taken from http://www.heyu.com introduction: "Heyu is a text-based console program for remotely controlling lights and appliances in the home or office. The complete source is made available under the GNU GPLv3 license. Heyu uses the CM11A computer interface to send and receive X10 control signals over the AC power lines to modules which can turn On, Off, or Dim attached lamps or appliances. It can store a schedule of timed events in the CM11A memory for execution without any more computer intervention." It is also mentioned that " Heyu supports an optional W800RF32A, MR26A, or RFXCOM RF receiver connected to a second port as an auxiliary input device for RF signals from X10 and other supported transmitters. Heyu can also use an optional CM17A interface to transmit X10 RF signals." Though what follows has only been tested on the CM11A computer interface. 

==Prerequisites==

==Configure the System==

===Loading the Package===
Load the heyu.lrp Package by adding heyu to the list of Packages specified in the leaf.cfg file on the boot media. There are no dependencies for this Package.

===Configuration files=== 
To start and test heyu.lrp the default configuration files /etc/heyu/x10.conf and /etc/heyu/x10.sched should work.

===Test your setup===

===Troubleshooting===

===Automating heyu start===

==Further Readings==
----
{| summary="Navigation footer" width="100%"
| width="40%" align="left"   | [[Bering-uClibc 5.x - User Guide - Advanced Topics - Setting Up a HTTP Anti Virus Proxy|Prev]]
| width="20%" align="center" | [[Bering-uClibc 5.x - User Guide - Advanced Topics|Up]]
| width="40%" align="right"  | [[Bering-uClibc 5.x - User Guide - Advanced Topics - Modifying initrd.lrp|Next]]
|}

[[Category:Bering-uClibc 5.x]]
[[Category:User Guide]]